Keith, You are correct. I will *try* to see who is owner of the document and see if it can be corrected. I am glad to see that you did enough research to realize that the switch had been changed to a 3 pin header.
73, Don W3FPR On 5/22/2012 9:31 PM, Keith Hamilton wrote: > The KBT2 Internal Battery Installation Instructions need to be > updated or have a errata attached. The instructions on page 8 > refer to a "S1" switch on the control board. I searched the > archives and found out that the switch was changed to 3 pin header > "P7" after about serial number 3000 or so. > > So to prevent others from this confusion the instructions need > changed or added to. > > 73 > Keith Hamilton N8CEP > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
