Bob This is forwarded to the list as it was only sent to me, and I do not have an answer. Maybe someone else does on the list
Sent from my iPad On 2012-05-22, at 23:52, Bob <[email protected]> wrote: > Has anyone found a 3.5mm 4-conductor cable with shield in what I would call a > traditional location -- the Sleve? It seems like the iPhone and Video cables > put the shield on Ring 2. I have some bare connectors, but figured it would > be easier to cut an existing cable apart and solder/heat shrink that to the > SignaLink cable, than try and solder the connector on. > > Tigertronics had first article cables for the KX3, but they were not > right-angle, so they have redone them and say they will be out later this > summer. It is suggested that a 47uF 16V cap be put in series with the mic > line to block the DC bias from the KX3 (in case you forget to turn it off -- > which I am likly to do). Put the + end toward the KX3 line and the - end > toward the SignaLink. > > Until then I've got the smallest tip I could find for my Weller iron lots of > tiny heat-shrink and four connectors -- hopefully one of them will make it > 'alive' > > 73, Bob, WB4SON ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
