Agreed. Right now, I think all you can do is kick in the attenuator and reduce RF gain on RX before recording. Not an elegant solution at all. Maybe with your post, it may percolate up "The List". 73, Bruce, N1RX
-----Original Message----- From: Dave [mailto:[email protected]] Sent: Monday, May 28, 2012 6:06 PM To: Bruce Beford Subject: Re: [Elecraft] KDVR3 output level adjust for over the air playback? I hope they can address it in firmware. Works well except over-the-air playbacks on rx are very hot in level Used it when we ran a special event station a few weeks ago and the dvr was a must! 73 Dave wo2x Sent from my iPhone On May 28, 2012, at 6:55 AM, "Bruce Beford" <[email protected]> wrote: > Not yet. Many of us are hoping a future firmware update will address that. > 73, > Bruce, N1RX > >> Playing with the KDVR3 and understand that tx audio processing has an >> effect on DVR recording playing back over the air. With my setup with >> mild compression and mild EQ'ing the ALC pins on playing a reciording >> over the air (recording someone and playing back over the air.). > >> Is there a way to pad it down to get the ALC level proper? > >> Thanks >> Dave >> wo2x > > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
