Ummmm ... if I understand your question, "yes." I've never seen a time that the OPERATE/STANDBY messages did not appear when I switch between OPER and STBY, regardless of whether I go to standby with the button or by changing bands. If it's in STBY and I change bands again, I get no message [or course].
The most prevalent "anomaly" is staying at 5W after using the K3 TUNE function. It's immediately apparent because I only get about 50W out of the KPA500 when I put it in OPER, and when I adjust the PWR setting, it is at 5W. It doesn't happen all the time. The second most prevalent is when I put the KPA500 in STBY and then find that the K3 power is still at 26W. Putting the KPA500 in OPER and having the K3 power stay at 100W has only happened once. 73, Fred K6DGW - Northern California Contest Club - CU in the 2012 Cal QSO Party 6-7 Oct 2012 - www.cqp.org "Anomaly" is a term used by NASA to describe anything from a burned out panel lamp to the rocket ending up pointy-end down in the desert outside of Tucson. On 5/31/2012 9:21 PM, iain macdonnell - N6ML wrote: > Fred/Gary, > > When you experience these power anomalies, do you see the KPA > operate/bypass messages on the K3 or not? I realise that it's one of > those cases where you don't know that you need to pay attention until > it's too late ..... but then the same could be said for your proposed > solution........ > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
