I have a K2 with the KPA100 installed and have just finished the KAT100. I
power the rig with an Astron SS30. I have been thinking about where to get
power for the KAT100. What I am thinking about doing is to remove and/or
jumper D10 in the K2. This would put 12V on the K2's J3 (12V DC Jack) on the
back of the K2. I could use J3 as an auxiliary power source, with just a
short cable from the K2 to the KAT100. Any comments about this idea? Good
Idea or Not?
Brent WB4X
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
