Hi Paul, I think what you're asking is why the P3's VFO B cursor flashes when you tune the VFO A cursor rapidly That is caused by the fact that the VFO B cursor does not update as rapidly as the VFO A cursor. There are a couple solutions:
- Unlink the VFOs on the K3 by holding the SUB button. - Turn off the VFO B cursor in the P3 via MENU: VFO B Alan N1AL On Wed, 2012-06-20 at 14:28 -0400, Paul VanOveren wrote: > I must have changed something in the configuration of my P3... With the > cursor type set as “bar” and in the the “finest” rate, 3 # to the right of > the decimal, everything is fine. In the next coarser rate, 2 # to the right > of decimal, I get a line, like the B marker is on, on the left edge of the > curser. In the coarsest rate, 1 # to the right of the decimal, if I tune the > A VFO rather rapidly, I get flashing B marker lines, above and below the > center frequency curser.. > Maybe what I am asking is how to shut the Purple VFO cursor off, it moves > with either the A VFO or the B VFO.. > > NF8J > Paul > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
