Cameron, Check the locations of the other 8 pin ICs to be certain their placement is correct - in other words, read the numbers printed on the component and compare with the location/parts list. What I am saying is that Elecraft has never had a shortage of ICs, or an incorrect count in my 13 years of experience with them (and I have assembled a LOT of kits for customers). But that does not say that mistakes cannot happen - but the most likely is that you mounted the LM6482 somewhere else. Check the IC labels carefully with a magnifier and a good light.
Once you satisfy yourself that you were shorted an LM6486 and have an extra 25LC320, email [email protected] and request an LM6486. With your K2 serial number and order date, there should be no question about sending one to you. 73, Don W3FPR On 6/23/2012 2:10 PM, Cameron Haines wrote: > Finishing up this board today and run into a snag. U3 shows to be a LM6482 > but I have only the 25lc320 left; is this part a substitute? I looked at part > list but did see anything in regards to this part number. > > Many thanks, > Cameron > AE5UZ > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
