I have regained comm with the K3 and load 4.51 successfully. Going through everything, again, I tried the PWR on/SHIFT LO on p 32 of the KE7X manual. This time it worked. That enabled comm between computer and radio, etc. So, I think this is working. Thanks again to everyone for responding. Aside from specific suggestions - all appreciated - just having the Elecraft community out there was reassuring which enabled me to keep plugging along. That's as good as any specific suggestion. Thanks much to all.
...robert On 6/30/2012 14:43, Robert G. Strickland wrote: > I have "lost contact" with my K3. I was trying to load the 4.51 firmware > when I got an error report in the K3 utility program, and the K3 became > unresponsive. Now, the TX light is blinking and MCU LD displays on the > lcd. The computer terminal program keeps trying to establish contact > with no results. In the K3 utility notice window, the program is > continuously cycling through various baud rates with no luck. I tried to > reset the radio using the PWR on - press SHIFT/LO 0 [KE7X p32] but > nothing happens. I have shut everything down and powered back up but > without results. The red TX light and MCU LD is all that I can get. Thanks. > > ...robert > -- Robert G. Strickland, PhD, ABPH - KE2WY [email protected] Syracuse, New York, USA ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
