Inputting 10MHz to K2 but no IF on rear BNC. Measured signal level from K2 at input of Z10000 board is 35mV, on U901 pin 3 level is 10mV, but 'scope shows no signal at pin 6. Connecting K2 IF op to K3 ae input a very weak oscillation can be heard. Suspect AD8007 IC has gone, but what signal level should be expected at Z10000 output? -- Robert [email protected]
-- http://www.fastmail.fm - The way an email service should be ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
