Gregg, The capacitors are not the problem - never were, that was a premature conclusion (the cap change seemed to work at first). The real problem is that the manufacturer changed the 1.6 ohm 2 watt resistors to an inductive design and did not notify Elecraft.
Give Scott a call or email [EMAIL PROTECTED] to request 2 replacement resistors. You can likely leave the 5600 pf capacitors in place with no problem, or you can change them back to the 4700 pf value if you prefer. 73, Don W3FPR > -----Original Message----- > > I just performed the KPA100 cap mod to as I had a HiCur indication. > Replacing C80 and C81 did not correct the problem. After the mod > I am seeing > the following indications as read on the K2 display. > > KPA100 off 20 meters > 12.8v 2.62a 13.7watts > > KPA 100 on 20 meters > 11.9v 4.04a 98 watts > > The power supply is delivering 13.2v key down with the KPA100 as > measured at > my DC distribution point. > > I have checked all of the solder joints on the KPA100 input network. No > problems were found. Operation on other bands seems to be OK. > > -- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.338 / Virus Database: 267.10.13/78 - Release Date: 8/19/2005 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
