Eric, unfortunately this is normal due to low isolation between HF and TRV ports in the K3. :-( Only way to cure it is disconnect HF antenna when using the internal 2 m transverter (or use a relay to switch it off externally instead of completely disconnecting it).
73, Olli - DH8BQA ----- Original Message ----- From: "F4AAG" <[email protected]> To: <[email protected]> Sent: Tuesday, July 17, 2012 6:46 AM Subject: [Elecraft] K3. 28MHz listen on 144MHz > Hello all, > I use a k3 equipped module 144. I can observe when a signal is present > on the QRO 28MHz is also heard on 144MHz. > This is it normal or transceiver is failing. > > F4AAG Eric > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > > ----- > E-Mail ist virenfrei. > Von AVG uberpruft - www.avg.de > Version: 2012.0.2195 / Virendatenbank: 2437/5135 - Ausgabedatum: > 16.07.2012 > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
