Thanks, Don! I made the AF Gain mod a long time ago. But that pot and the IF gain pot are now flaky. It's been more than 12 years (and plenty of hard use) so I'm not complaining.
On 7/20/2012 12:31 PM, Don Wilhelm wrote: > Vic, > > You will have to remove the top cover and then remove the two screws holding > the front > panel and Control Board together, If you have either the KDSP2 or KAF2, you > will haave to > remove that first to get to the standoff that holds those options in. > > Once th eFront panel is free from the control board, remove the 4 screws at > the corners > and pull the front panel forward. > > You can then remove the knobs and the metalwork to get at the board and > remove the pots. > > If you are replacing the audio pot and your serial number is below 3000, give > strong > consideration to installing the Alternate AF Gain Wiring Mod. It only > involves wire, and > is a worthwhile addition. > > 73, > Don W3FPR > On 7/20/2012 1:45 PM, Vic K2VCO wrote: >> I haven't had my K2 apart in years, but I need to replace two pots on the >> front panel >> board. >> >> Is it easier to remove the control board and front panel from the RF board >> and then take >> that assembly apart, or can I just remove the knobs and the front panel >> sheet metal and do >> it from there? >> > -- Vic, K2VCO Fresno CA http://www.qsl.net/k2vco/ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
