Don, It would appear that you may have something wrong in the 160 meter low pass filter. Count the turns on the toroids, and check the capacitors for the correct values.
You are measuring the power output with a good 50 ohm dummy load, are you not? If you are attempting to feed an antenna, the power output may be real, but the problem is the feedpoint impedance of the antenna and not the K2. Please povide ua with more information of what does and does not work, if we are to offer more specific assistance. 73, Don W3FPR > -----Original Message----- > > I built and installed the 160 meter module in 2000, but didn't > align 160 meters since I didn't have an antenna at the time. I > have recently completed my KPA100 and before closing up the rig, > I decided to align 160. I receive signals on 160, but can't get > more than 1.4 watts out, even when setting the power to 10 watts. > I have resoldered all the components on the module board and the > RF board. I believe that my toroids are connected ok. I have > full output on 80 meters. > > Don - KA6AKH > -- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.344 / Virus Database: 267.10.15/81 - Release Date: 8/24/2005 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
