On Sun, Jul 29, 2012 at 3:17 PM, Jim Bennett <[email protected]> wrote:
> Hi -
>
>> I just finished installing the sub receiver in my K3 # 4359. Set up the
>> filters, sub synth, etc.The subrx book sez (page 44), that if you press &
>> hold the SUB for 2 seconds or more it will go into Diversity mode. That it
>> does. It also sez that the kHz dot on VFO A will flash, to indicate
>> Diversity mode. That it does. But it also sez on page 45 that when this is
>> done, it sets the sub to the same frequency as the main (VFO A). It does NOT
>> - frequency in VFO B stays right where it was. I did find a way to make it
>> work, but I'm wondering if the book is wrong, if I'm not reading it
>> correctly, or if there is a screw-up in the firmware. I did download the
>> most recent non-beta f/w into the K3.
>>
>> On my K3 I have to first do the A>B twice to get both VFO's on the same
>> freq, with the same settings, then go into Diversity mode, and finally press
>> the SUB button again for less than 2 seconds to make it "Link". This keeps
>> it in Diversity mode and "Links" the two VFO's on the same frequency. If it
>> worked as the book sez on page 45, it'd be a lot easier. Any suggestions?
Jim,
When in diversity mode, the VFO B display does not represent the
Sub-RX (as it does not when the Sub-RX is turned off). It's done this
way because you can operate split while diversity is on - i.e. a TX
frequency that is different from the frequency that the two receivers
are locked together on.
So, basically, ignore VFO B when experimenting with diversity RX.
73,
~iain / N6ML
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
