Hi Don, Yes you will need the KXV3A.
I originally did not have the KXV3A and I later added it to my K3. It is a very easy option to install. That was a few years ago but I would venture to say that it took far less than one hour. You'll have to first remove the I/O board. This is the board with the RS232 and ACC connectors. Be extremely careful not to over tighten the standoffs on either side of those two connectors when you reinstall this board. After installation it is necessary to change CONFIG:KXV3 from NOT INST to NOR. 73, Mike K2MK goldtr8 wrote > > I think that I need to add KXV3a to my K3 if I want to connect a PAN > adaptor or P3 of some sort. So do I have the right item identified. > > Currently I do not have that option installed. It seems a low cost item > but the bigger question is what is a reasonable amout of time required > to install it. > > I have a K3 100w version with no sub receiver. > > Thanks > > ~73 > Don > KD8NNU > -- View this message in context: http://elecraft.365791.n2.nabble.com/PAN-Adaptor-interface-question-tp7560377p7560385.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
