Those holes are for the KXPD3 paddles - you can ignore them. Elecraft always gives you some extra hardware - just in case.
Buck k4ia On 8/7/2012 11:36 AM, Kevin Luxford wrote: > When I finished the build of the KX3, there were a couple of small flat > head black screws left over. I found a couple of spots where they > fitted, but for the life of me I could not find reference to them in the > assembly instructions. These screws seem to go on either side of a male > connector visible in the window of a square cut-out on the top cover. > Further, I could find no reference to this 4 pin connector. Has it > something to do with the yet un-released 2 m option and linear amplifier? > > I have gone through both the assembly and operator's manuals at least > three times, however, this is no guarantee that I have not overlooked > the explanation I am looking for. > > 73 > Kevin > VK3DAP / ZL2DAP > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
