Removing the KPA3 module is a straightforward process and should not result in *any* damage, Hi! The process is documented in a mod sheet describing a very desirable change to the connectors in early K3s, but I can't find it on the Elecraft web site. So look for a direct e-mail message; I'll attach it for you.
73, Ron AC7AC -----Original Message----- I have a K3 which I recently inherited. Unknown to me at the time, it has no TX/RX on 160m. The Guys at Support led to look for a possible fault in the Low Pass Filter area. I believe that this is beneath the 100W PA unit on the main board. What is the easiest/safest way to remove the PA unit without causing unnecessary damage? Also, is there a layout drawing of the main board? Thanks Roger G0IUW ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
