No problem to parallel as many inputs to PTT as you desire. Just make sure that the ones you aren't currently using are open. I have foot switch and Remoterig on a simple Y connector from radio shaft.
On Wed, Aug 15, 2012 at 3:26 PM, paul ecker <[email protected]> wrote: > Hope I am not expending my quota of dumb questions but hey I am new. Got > my Tx foot switch plugged into the back panel PTT jack and it works fine. > My next project is to get my SignaLink USB up and running with the K3. I > know I can do lots without it but I would like to not use the PC sound > card. So here's my problem- I got the SLCABK3 cable from Tigertronics which > has 3 leads on radio end: Line In, Line Out and PTT. But the my PTT jack > is used already. What it i were to make a Y cable allowing two PTT inputs > to the K3. Signalink only used for digital modes, so it's an either or > situation, both would not be used at the same time. > - Is this doable, not going to harm the K3? anyone else encounter this > problem? > 73 & tnx > Paul kc2nyu > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > -- Jim K0XU [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
