Al, I would start with the Calibration Reference Oscillator Calibration as indicated in the manual (use Method 2). After doing that, the K3 ref osc calibration should be correct, and all other discrepancies should be with the P3. Refer to the P3 documentation for corrective actions.
73, Don W3FPR On 9/4/2012 11:09 PM, Al Lorona wrote: > Something that I've not been able to do successfully: > > Tune to a standard frequency station, like WWV on 10 MHz. Center WWV on the P3 > screen (in other words, make the Center Freq = 10000 kHz exactly). > > I want to span down from 20 kHz to the minimum span, 2 kHz. > > NOTE: FixTrack = Fixed-tune mode for the following. > > As I span down, the center frequency shifts to something like 10002 kHz. So > then I try to adjust the center freq back to 10000 kHz exactly, but the P3 > won't > allow it. As you approach 10000 suddenly the center frequency jumps back to > 10002. > > > It's an aggravation. Maybe it's a function of my FixTrack settings but I > haven't > been able to understand why. > > > Al W6LX > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
