Mike, I have had each of my K3's tight up against the 2000A, 91B and 87A (transformer side)without any issues. But I must say at one point I had a cockpit error when I upgraded the firmware. For some reason the Line-In was at maximum. I was getting hum on my transmit audio if I was closer than a several inches from a transformer. Used a piece of steel as a shield that helped till I figured out what was going on. Reduced the Line-In and everything has been fine since. Duh!
73, N2TK, Tony -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Mike Harris Sent: Thursday, September 06, 2012 5:06 PM To: [email protected] Subject: [Elecraft] Location, location G'day, Might be having to reconfigure the equipment layout. Anyone with experience of running an Acom 1000 or similar chunky linear with the transformer side only about 1 foot away from the left hand side of a K3. That is right hand side of Acom to left hand side of K3. The gap is currently approximately two feet with no apparent ill effect. Regards, Mike VP8NO ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
