Good morning, I am wondering if the calibration procedure, reported on pag. 4 of KXFL3 manual rev A2, can be executed using RigExpert AA-54 embedded signal generator. As stated in AA-54 manual, signal has rectangular waveform and a level of about +13 dBm (at the 50 Ohm load). On the other side, in KXFL3 manual, the required signal should have a level between approximately -73 and -33 dBm. Could this level difference damage filter board or cause other kinds of troubles?
Thank you. 73', de Enzo IW7DMH -- View this message in context: http://elecraft.365791.n2.nabble.com/KXFL3-Calibration-Procedure-Signal-generator-question-tp7562476.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
