Wayne, Joel was talking about the K3, not the KX3. You certainly need a break from KX3 firmware optimization, don't you? ;-)
73, Olli - DH8BQA ----- Original Message ----- From: "Wayne Burdick" <[email protected]> To: "Joel Hallas" <[email protected]> Cc: <[email protected]> Sent: Tuesday, September 11, 2012 8:13 PM Subject: Re: [Elecraft] K3 VFO encoder noise? > Joel Hallas wrote: > >> While dabbling in the VHF contest this w/e, I noticed that there was >> low >> level noise as I turned the main VFO knob. It just seemed to be on 6 >> meters. >> It wasn't a big problem, but I think some rigs have s/w options that >> take >> care of that, but I didn't see anything in the K3 menus. > > Hi Joel, > > This noise is typically not audible except on the highest bands with > very little band noise (or no antenna). You have a choice of methods > to eliminate it if necessary. > > All of the following settings are per-band so you only need to try > them on affected bands: > > 1. Set MENU:VFO NR to ON. > > 2. If necessary, set MENU:RX SHFT to ON. > > 3. An alternative to (or supplement to) the above is to turn on the > regular receive noise reduction by holding the NR switch. > > 73, > Wayne > N6KR > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > > ----- > E-Mail ist virenfrei. > Von AVG uberpruft - www.avg.de > Version: 2012.0.2221 / Virendatenbank: 2437/5262 - Ausgabedatum: > 11.09.2012 > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
