Lucia,

Is your KX3 menu parameter for the ATU MD set to "AUTO"  If not, the 
results may be as you have experienced.

73,
Don W3FPR

On 9/18/2012 10:36 PM, luca de marinis wrote:
> Hi Don, I read the 1.4 SWR on my MFJ 259b then tuned with the KX3 atu to 1.0
>
> On transmitting the swr graph showed peaks near to 2 and if I press the XMIT 
> (tune) the reading is about 1.4 same as without ATU.
>
> Luca
>
>
>
>
> On Sep 18, 2012, at 7:12 PM, Don Wilhelm <[email protected]> wrote:
>
>> Lucia,
>>
>> You say that you had an SWR of 1.4, then used the ATU which lowered the
>> SWR to 1.0
>> OK, That was on the KX3 display.
>>
>> Please tell us where you were reading the continued 1.4 SWR.  The KX3
>> display does not show the SWR during transmit - only during a TUNE.
>> The SWR shown externally to the KX2 ATU will not change, so if you are
>> using an external device, you will not see any  change in the SWR reading.
>>
>> The KX3 ATU will reduce the SWR between the KX3 output PA and the input
>> to the KXATU3 to the value shown during on the KX3 display during a
>> TUNE, but the SWR between the KXATU3 and the antenna (as measured by an
>> external device) will not change.
>>
>> 73,
>> Don W3FPR
>>
>> On 9/18/2012 8:14 PM, luca de marinis wrote:
>>> Hi,
>>>
>>> I completed my KX3 #1715 few days ago and today I went to the park and 
>>> using a Buddipole I tried to make some contacts. Buddipole swr was 1.4 on 
>>> 20m so I used the ATU. It worked fine lowered the swr to 1.0 but then I 
>>> transmitted I still could read a 1.4 swr. I moved up and down the band and 
>>> tuned again and every time the ATU started from 9.9 and did the all cycle. 
>>> Sometime couldn't go lower than 1.4. Sometimes after tuning the power was 
>>> reduced to 2W
>>>
>>> Am I missing something. I did a search on the reflector but didn't show 
>>> anything.
>>>
>>> Thank you in advance for your help
>>>
>>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:[email protected]
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

Reply via email to