I hope this topic will be short-lived...
I have just received several GERBER files for a PC board I'll be working with.
I only have the freeware versions of EAGLE and ExpressPCB to use.
Does anyone know if the Gerber files I received can be imported into either
Eagle or ExpressPCB? If so, how?
And finally, is anyone aware of a program (hopefully free) which would at
least permit me to view/print the (imaged) contents of the Gerber files I
have? At present, I have no clue what was actually sent to me, so I'm not
certain if they're only drill hole info or actual plot files.
PLEASE REPLY DIRECT TO ME and OFF REFLECTOR. I don't want to create a lot
of bandwidth on the reflector.
73,
Tom N0SS
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
