I would recommend contacting Elecraft product support for guidance regarding the ERR TXG message. The K3 Owner's manual describes this message on page 70.
Tx Gain calibration succeeds if the K3 displays the expected power levels during calibration. 73 de Dick, K6KR -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Sunday, October 07, 2012 5:51 AM To: Elecraft Group Subject: [Elecraft] K3 : ERR TXG on 50W TX Gain Calibration routine... Hi Group, I've just re-run the TX Gain calibration routine on my K3 using the K3 Utility 1.12.9.22 and hit a snag. 5W and 1mW calibration routines run perfectly, all bands. On the 50W calibration, on the 50Mhz band, the K3 LCD display show the ERR TXG message. All other bands calibrate without error at 50W. The K3 Utility reports no error - it confirms in its last message that the 50W calibration routine has completed successfully. So do I believe the K3 LCD ERR TXG message, or the K3 Utility's "success message"? Where do I look now? I've run this routine several times before without any reported errors Thanks for any advice, 73, John VK7JB ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
