Hi Todd, I did put out an announcement several weeks ago about the 1.18 beta, however since that time I just released the new 1.20/1.10 P3/SVGA firmware. Everything that was in the BETA is in the new release, albeit with additional fixes and features.
If you are having trouble downloading firmware to the P3/SVGA, try the following: 1) Verify that you are using version 1.12.4.26 or later of the P3 Utility. 2) Make sure that there is no other application running on your computer such as a logging or control program that would affect the serial port going to the P3 and/or K3. 3) If you have the P3 utility running, close it down. 4) Power the P3 off, then on and wait 30 seconds. 5) Start the P3 Utility. 6) In the P3 Utility window, click on *View * and select *Advanced Mode*. 7) Click on the *Firmware* tab. 8) Under the Load column, ensure that all the check boxes are UNCHECKED EXCEPT FOR *SVGA*. 9) Click on the *Send Checked Items to P3* button. 10) The SVGA board should now load correctly. After loading the SVGA board, you can continue to load the individual FPGA files using the check boxes. 73, Paul Paul Saffren - N6HZ Firmware Engineer Elecraft Inc. 831-763-4211 x122 www.elecraft.com -- View this message in context: http://elecraft.365791.n2.nabble.com/P3-SVGA-firmware-Version-question-tp7563835p7563845.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
