This is what the KPA500 would normally look like when the front panel power is off. It's the KPA500 boot block code's response.
If the KPA500 is turned "on" and has a valid firmware load, it should respond differently. Dick, K6KR -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of iain macdonnell - N6ML Sent: Monday, October 08, 2012 2:24 PM To: Phil LaMarche Cc: [email protected] Subject: Re: [Elecraft] KPA500 Utility Com 1 On Mon, Oct 8, 2012 at 2:17 PM, Phil LaMarche <[email protected]> wrote: > Downloaded all new firmware for K3 and P3. Looked at KPA500 new > version check and was unable to connect. Saw a message I've never seen before.. > > > > KPA waiting for Power button or firmware load. RS232 38400 > > > > Has always worked before???? Double checked all cable and com port. I saw this recently too. Have you tried hard power-cycle (i.e. using the switch on the back, not the button on the front) ? 73, ~iain / N6ML ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
