I was attempting to run the transmit bias test and all that is happening is
both for CW and SSB when I press XMIT on the LCD I get a reading of .04A
ranging up to .09A and Q6 below that. The instructions say this test is to
take between 3-10 sec my test was into 1.5 minutes. The LCD just continued to
role between .04A and .09A. I tried SSB and the same thing happend just the
numbers were from .08A-.18A again with Q6 below the reading. I was not getting
an error message and there was nothing on the BNC connector and I did unlock
the TX Bias menu.
Mike
VE3WDM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
