In the past, instead of transcribing the content of the errata into the main manual I have simple added a note at the appropriate place "see errata #1" and so on. Saves a lot of writing.
Regards, Mike VP8NO On 14/10/2012 14:04, Phil Hystad wrote: > Joel, > > Thanks for the clarifying comment below. I remember reading the errata and > marking up my documents with changes but I totally briefed over the part > about the change to calibration (you noted below) and then forgot about it. > > This was done in the rush to process all the errata sheets to get required > changes written into the manuals and my main focus at the time were > changes to installation and assembly, not to other stuff. Oh, well, my > fault for doing this late on Wednesday night when I should have been > in bed asleep. > > 73, phil, K7PEH ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
