Bob, I don't have a source, but I need to give you some information regarding the 9 pin connector.
The 9 pin 'Y' may give you problems. RS-232 signalling is for point to point communications only. If there are two drivers on a signal line, they will interfere with each other (even if idle). In other words, if there is anything connected to pins 3, 4 or 7 in the device on the far side of the "Y" connector, it will interfere with communications between the K3 and the computer (Microham Digikeyer). In other words, you cannot connect another device that normally drives an RS-232 interface. Anything that is connected to the "Y" must be 'listen only' 73, Don W3FPR On 10/15/2012 8:02 PM, Bob Garrett wrote: > Greetings Listers, > > > > I'm getting ready to configure my K3 with my THP amplifier, Microham > DigiKeyer II and my K3 Pod with is a speech box for us blind hams. I know > connecting more than one device to a 9 and/or 15 pin port is a slippery > slope however, I need to do it and will figure out the conflicts along the > way. > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
