KX3 production firmware rev 1.23 (with DSP rev 0.99) is now available.
See release notes below. This update is appropriate for all KX3
owners, especially if you are installing a KXBC3 battery charger.
You'll need our KX3 Utility application to download and install
firmware. For full instructions, refer to our KX3 software page:
http://www.elecraft.com/KX3/KX3_software.htm
Thanks,
Wayne
N6KR
* * *
MCU 1.23 / DSP 0.99, 10-17-2012
* FM MODE SELECTION AF ARTIFACT: Eliminated.
* RECEIVE AUDIO LOST ON BAND CHANGE: Fixed.
* KXBC3 TIME-SET ERROR (etc.): Fixed. In very rare cases, KX3s were
unable to communicate with the KXBC3 module.
* XVTR BAND DISPLAY FIXED for cases where 100’s of MHz digits are 00
(e.g., RF band = 3400 MHz).
* SIDETONE MAX VOLUME SETTING INCREASED to 40. Note: This is a very
high level. We increased it to support those with hearing loss or very
inefficient headphones. Most operators will use settings in the 1 to
20 range.
* RIT/XIT NEVER LOCKED: VFO lock now only applies to the VFO, not RIT
or XIT.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
