You can remove the resistor pack by using heated solder on all the pins on one side. (You need to be fast!) Heat up one side with the soldering iron and apply lot of solder, the solder works as a heat distributor, losen one side, and do the same on the other side, use solder wick after to remove all the solder from the PCB and the resistor pack.
Martin Storli LA8OKA Oslo, Norway  ARCTICPEAK's Radio pages! http://www.arcticpeak.com/radio.htm ________________________________ Fra: Gil G. <g...@keskydee.com> Til: Elecraft@mailman.qth.net Sendt: Fredag, 19. oktober 2012 1.35 Emne: [Elecraft] Resistor networks, polarized? Hello, I am building the KSB2 tonight, and I put a resistor network the wrong way.. Aren't these just resistors? Why would there be a pin 1? Should I remove it? If so, how do I do that? I have solder wick, tried, but it isn't budging… Thanks, Gil. -- PGP Key: http://keskydee.com/gil.asc ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net/ Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html