In process of building an older K2 kit, SN 3943. I'm at the Part 1 alignment
page 42 - the optical encoder test.
Status: All ok to this point with display reading 40M 7100.00c and VFO A
However, the indication does not change when turning the VFO knob. I've
verified per the steps in Appendix E 012 on page 2, voltages in step 050 on
page 3, and all of step 075 on page 5. The 4 mhz osc can be heard in my
station receiver and will change when I adjust C22 on the control board.
The next test: the relay test appears to work as the band changes and the
display reads out for each band. But as with the 40M position, the frequency
does not change when turning the VFO knob.
Is there anything I should check before beginning the voltage checks beginning
on page 15?
Any suggestions would be appreciated.
Cecil, K5YQF
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
