Ok that's what I'd thought about the resistance value there - the note (on Info 080 troubleshooting, in builder resources) had said that the resistors should be 470 ohm, and that the range should be 900-1000 ohm. However all through the manual those resistors are referred to as 100 ohm, which is what I have installed at those points, and my measured resistance value of around 198 ohm would be just about dead on. So no concern there.
Just have to figure out what my VFO knob problem is now - checked solder points on the small optical encoder board and then gave it another shot, and it's still not working. Just as before with the sudden appearance of the Info 080 message, there's probably one solder point somewhere that's flaky and it's causing my problem. -- View this message in context: http://elecraft.365791.n2.nabble.com/Info-080-message-started-with-RF-Alignment-and-Test-Part-II-tp7564545p7564638.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
