On Oct 28, 2012, at 5:51 AM, Mike K8CN <[email protected]> wrote: > It sounds like re-heating of the solder connections on both sides of C121 is > in order. The fact that your RF voltage on terminal 3 of T1 has the proper > ratio to that on terminal 1 implies that T1's solder joints are OK. The > absence of RF on the driver (Q6 base circuit) side of C121 could be due to a > very low impedance being presented there, but this would have been reflected > in a much lower voltage reading at terminal 3 of T1 ** if ** C121 was > properly connected.
Thank you (and Don) very much for your help! Reflowing C121 fixed it, and my K2 is now complete. Now I just have to come up with an antenna, and I'll be on the air. Cheers, Ben (KJ6ZGJ) ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
