Make sure as well that the flex cable is plugged in correctly. I suggest reviewing the section of the manual.
73 Jim WB8AZP Sent from my iPhone On Nov 4, 2012, at 8:15 AM, Matt Zilmer <[email protected]> wrote: > Try re-seating the flex cable between RF and FP boards. > > matt W6NIA > > On Sat, 03 Nov 2012 21:03:34 +0100, you wrote: > >> Hi, just assembled the Kit S/N 2294 with KXAT3 and KXFL3. No problems >> during assembly. I used anti static wristband and mat. >> >> Tried 12V battery and linear power supply. While pressing BAND- and ATU >> TUNE the four LED light up. After releasing the buttons the LEDs switch >> off and the display backlight turns on. That's all. No display, no >> message,s no sound. Nothing. And the KX3 won't switch off. >> >> >> Any suggestions? >> >> >> regards >> Holger - DL9HDA >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
