On Mon Nov 12 13:33:28 EST 2012, PJ wrote ... I noticed that on page 48, Fig.70 the text again emphatically warns to use a split washer under the hold down screw while the picture shows an inside tooth washer under the screw
I have assumed that the text is correct as in many other places in the manual a split washer is used for this type mounting. I could be wrong ... PJ, Actually the text does not say that. Rather, it states "Be certain you use a split lock washer between the KREF3 board and the PEM nut attached to the shield." Further, the drawing and accompanying detail text show and describe that the lock washer under the screw head should be of the inside tooth variety. 73, Gary KI4GGX K3/100 #2724 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
