OK...I got this figured out. I have SPLT SV set to "on" in the CONFIG/TECH MD menu.
As long as I change bands with the K3 and NOT by clicking on a spot in the logging software, the K3 operates like it's supposed to....NOT turning off split and remembering the split setting by band. However, if I change bands by clicking on a spot in the logging software the logging software turns off the split when it changes bands. Thanks to Joe W4TV for suggesting I check this. I confirmed this with both Logger32 and N1MM. I do not believe there is a way to defeat this with either logging program, unfortunately. At least for day-to-day operating with Logger32 that would be nice to be able to select the split behavior. Thanks for all the responses on and off the reflector. On 11/13/2012 11:05 PM, Gary K9GS wrote: > On the K3....say you're on 160M with split activated and the sub > receiver turned on. Then you change bands to, say 80M. A few minutes > later you go back to 160M. > > The K3 goes back to the original VFO A and VFO B frequencies as before > but the SPLIT deactivates. I thought that by turning SPLT SV to "ON" in > the config menu would stop this from happening but it didn't. > > Is there some other command I'm missing? > > > -- 73, Gary K9GS Greater Milwaukee DX Association: http://www.gmdxa.org Society of Midwest Contesters: http://www.w9smc.com CW Ops #1032 http://www.cwops.org ************************************************ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
