I have macros that do that with my logging program, DXLab, specifically its rig control program, Commander. I have them uploaded to the DXLab Yahoo reflector files website, <http://groups.yahoo.com/group/dxlab/files/Command%20Sequences%20%26%20Slide rs/Elecraft/> .
I do it by toggling two choices within the same macro (call a User-Defined Control in Commander). You could run just Commander without using the other features of DXLab if desired. http://www.dxlabsuite.com/ 73, Jim N7US -----Original Message----- I want to write two K3 macros, one for selecting the front panel Mic (MH2) and setting Mic gain and speech compression, and one for selecting the back panel mic (Yamaha CM500) and setting mic gain and speech compression. >From my reading of the K3 programmer's reference, I know the following: - Mic gain command is MG010 (000 to 060) - Speech compression is CP016 (000 to 040) - Mic select is MN053 - changing VFO A UP or DN . but I am not sure how to more discretely select front panel mic or back panel mic, and not sure about whether I need to use the MN255 to exit the MN command series. A potential command sequence is MN053;UP;MN255;MG010;CP016 . if currently set on the front panel mic to change to the back panel mic, I think. Though avoiding use of UP and DN would be preferable. I have entered two macros that I got from the Programmer's Reference, the SPLIT+2 and the CLEANUP, and they work just fine. Advice is appreciated. 73, Hoop K9QJS ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
