Make sure the "dial lock" function is not engaged. If it is, the decimal
point to the right of the 1 kHz digit will be flashing. If that is not
the case, then perhaps the encoder is not wired correctly, or there is a
solder splash or something similar.
Try direct frequency entry. To do this, press BAND+ and BAND-
simultaneously, release them, and use the 0-9 buttons for direct entry.
use 4 digits for 80, 60 and 40 meters, 5 digits for 30 meters and
higher, leading 0 plus 4 digits for 160 meters.
- Jim, KL7CC
On 11/23/2012 2:32 PM, [email protected] wrote:
Finally recieved my missing parts for the control board and fired up the K2
for the first test. All
the relays, switches etc. work fb. But I can't change freqs when I turn the
main dial. The rit works ok
No error messages. Guess I will have to take the front board out and recheck
everything..
Don....w2xb
--
View this message in context:
http://elecraft.365791.n2.nabble.com/k2-encoder-dial-tp7566137.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
