Also try and use "spot" to center it under "cwt" or it won't decode very well. I just tried it and it works with some of the cw machine guns operating in contest. Got to have a decent signal though.
----- Original Message ----- From: Matt Zilmer [mailto:[email protected]] Sent: Saturday, November 24, 2012 01:20 PM To: Mike Weir <[email protected]> Cc: [email protected] <[email protected]> Subject: Re: [Elecraft] No CW decode on K3 or P3 Make sure you have TEXT DEC enabled. Narrow the bandwidth, set THR to 2 or so, 30-90 WPM. My notes here say it was working fine on 4.51 / 1.17. 73, matt W6NIA On Sat, 24 Nov 2012 09:50:06 -0500, you wrote: > >Im in the CQ WW and some are just sending at bullet speed have noticed K3 and >P3 are not decoding anything. On the K3 just the VFO freq is displayed it does >not even attempt to show code. I have the test dec set to 30-90 (have tried >other settings) and threshold has tried all as well. Is there a setting in the >K3 were I shut down the decode?? Firmware is 4.51 on K3 and on P3 1.17 >Mike >VE3WDM > >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected] > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
