I'm confused as to the function of the receive equalization vs the width vs the
hi
and low cut.
Example - The traditional SSB filter is, say, a 2.7 KHz wide filter with the
bfo carrier 300 hz from one side of the filter passband. This provides audio
response
of 300 hz to (300+ 2700) = 3000 Hz.
So I can set my K3 to 2700 bandwidth and adjust the SHIFT control to give the
same response as above. But in addition I can adjust the 8 band receive EQ to
roll
off or peak this spectrum, right? I assume this filtering is at audio, after
the detector.
Then what are the hi cut and low cut front panel controls for? What do they
control?
Rick K2XT
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
