It sounds like the EEPROM data got corrupted somehow. Try doing a Parameter Initialization as described in the P3 Owner's Manual.
Alan N1AL On Sat, 2012-12-01 at 16:35 -0500, [email protected] wrote: > I just put together a new P3 and it isn't seeing the rig. It also will not > see the computer through the P3 Utility with the serial cable. If I unplug > power from the P3, I can see the K3 through the same cable using the K3 > Utility (same comport, 4). I am using an Aten usb adapter, but it works fine > on the K3 direct or through the P3 with power off. So, I assume its not the > cable or the USB adapter. > > I've tried various combinations of baud rates, but the P3 Utility just keeps > attempting to contact the P3 on port COM4 and never connects. > > Every time I turn on the P3 it says: > > P3 BOOTLOADER > INVALID SAVED STATE DATA > USING DEFAULT VALUES > CHECKSUM TEST > > The P3 is reading the IF input and displaying the Spectrum Display and > Waterfall Display, but doesn't show frequency (reads 0) and won't tap to QSY. > > P3 firmware shows to be 01.20 > SVGA firmware shows to be 99.99 and I get no video out to my monitor. > > Thanks for any help! > > Jeff > K0RG > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
