YOOOU! I was not dreaming... ;-) Now what's next ? Anyone have a
schematic or an existing project that look like this one and I could
start from ?
Le 05-09-18 à 21:28, Bob Nielsen a écrit :
JEAN-FRANCOIS MENARD wrote:
I'm looking at a way to merge enterely two K2 to the same
ressource: ONE mic and ONE multi-band antenna. So the setup
interface must be able to switch mic between K2, and when one K2
transmit, the receiving on the other K2 is muted.... and also
making sure that the RF is stopped and do not enter in the
receiving K2.... One Antenna for two K2.... when both K2 do not
transmit, they can listen on different or same band at the same
time.
Am I dreaming ? It must be possible to do this project ? ;-)
Sure it is possible, but a bit complicated. You would need to have
a PIN diode switch (or relay) to short out the input to the non-
keyed K2, as well as a few switches or relays to select which K2 is
transmit-enabled Mic, PTT and antenna. Some sequencing to make
delay transmit until after the input is shorted would be desirable.
73 et bonne chance!
Bob, N7XY
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
