I found the same. The screw in Figure 11 on page 18 is just filling an
empty hole, so I don't suppose it matters much which kind of washer is
used for it, and there's nowhere else to use the internal tooth washer
that was supplied.
Also, based on the parts supplied, the four 4-40 screws for the
through-board standoffs in figure 26 are apparently supposed to be 3/16"
(4.8 mm) screws, not 1/4" (6.4 mm) screws as stated in the figure.
73,
Rich VE3KI
John N1JM wrote:
I also had an extra star washer left over. I wonder if the spit washer on
page 18 was supposed to be a star washer?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
