I think what happens is KAT500 needs few msec to determine the operating
frequency and measure SWR. There is currently no delay between PTT going
into KAT500 from the radio and PTT going out into the KPA500. These few msec
is enough for KPA500 to switch itself to fault condition.
Here programmable PTT delay in KAT500 would be very helpful. Especially so
with other makes of the amplifiers.
I have discussed it with Elecraft tech support and they say this feature is
on their to do list. Lets hope that the next firmware revision of KAT500
will have that feature implemented.
73, Igor UA9CDC
----- Original Message -----
From: "Chris Johnson" <[email protected]>
To: <[email protected]>
Sent: Friday, December 07, 2012 3:35 PM
Subject: [Elecraft] [KAT500] Help with KeyLine Interrupt on KPA500 (Video)
Hi Guys,
I made a video and posted it on youtube to better explain the issue I'm
having. Please watch and then reply to it here if you would.
Much appreciated
http://www.youtube.com/watch?v=QtCPvKKM3_c
Chris
K6OZY
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
