Bob Wehking wrote:
I completed the KPA100 & everything works except I can't get the K2
to communicate with Logger32. I setup the radio for COM1, 4800 baud,
2 stop bits, no parity. Kenwood-all & have toggled both DTR & RTS on
& off. The cable is wired correctly based on the manual. I've checked
all the solder joints on the amplifier board associated with U4 &
they all look good. I also checked the resistance of all RF chokes
associated with U4.
Just in case you've missed the obvious, I note that you don't mention
setting PORT to ON in the K2 menu.
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
