My K2, which is newly built but was working fine ... spontaneously has started giving me a HI CUR reading even whenever I hit the TUNE button, even when going into a dummy load .... Regardless of the setting of the power output control ... ( the CAL CUR limit is set to 3.5). any advice as to where to start looking for a problem? Thanks.
------------------------------------------------------------------------------- This email message, including any attachments, is for the sole use of the intended recipient(s) and may contain information that is proprietary, confidential, and exempt from disclosure under applicable law. Any unauthorized review, use, disclosure, or distribution is prohibited. If you have received this email in error please notify the sender by return email and delete the original message. Please note, the recipient should check this email and any attachments for the presence of viruses. The organization accepts no liability for any damage caused by any virus transmitted by this email. ==============================================================================
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
