Rich,
Does the illustration following that text help at all? They are the
short ends of the 5 pin connector.
73,
Don W3FPR
On 12/23/2012 2:07 PM, Rich wrote:
Hi all
Am hoping someone can answer this one quickly.
I am building my K3 at the moment and am on page 32 of the manual just putting
in VFO B and I don't understand the instructions.
It says 'Cut only the five pins shown close to the back of the pc board so they
do not extend above the solder points'
Up until now everything has been easy to do but this has stumped me, can
someone explain what this means please?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
