I noticed that the MKR control with the knob on my P3 is very jumpy (i.e. not smooth) so I decided to check my baud rate of all equipment connected. Currently, I am running the K3/P3 with LOGic 9, and a SteppIR control (connected with a "Y" cable). I checked baud rates for everything, at they are all set for 38,400. I even verified that the baud rate of the computer port is set the same. However, the control is still far from smooth. I also noticed that when the K3 is showing the baud rate in the CONFIG menu, it will show 4800 baud when I press the DISP button. I can't find anything in the manual to explain. Perhaps I am not setting the baud rate correctly?
Allen R. Brier N5XZ / KL5DX 1515 Windloch Lane Richmond, TX 77406-2553 281-342-1882 (Home) 713-705-4801 (Cell) [email protected] [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
